Distributor Question.

Old filthy parts like that can be a chore for sure. Add some "after" shots for dramatic effect.

You can use a light grease on the shaft when you put it back in. The bottom gets splashed with oil, but the top of the shaft is only lubed by whatever gets pushed up there - which is not much.

I like to use Magnalube G for spots like that, but lubriplate is fine.

You do need to pay some attention to the top end of the shaft. The advance weights work better with a little lube, but they must move freely. If they are dry they also rust easily. I like to use Mobil 1 0W40 for the advance & breaker plate. Use a toothbrush, and scrub a little oil into all of the surfaces. Then blow off any excess oil with compressed air. Never see a rusty weight again.

B.