<<<<<430 cube small block mopar build>>>>>
Just a quick update - Been working a ton, but have managed to get over to work on things a few times and have not updated.
Just about ready to balance after checking and re-checking everything - the shop was impressed with the BPE setup to say the least. They started recommending them to guys inquiring about SBM setups. The fit and finish was better then anything they have touched before in this price range.
Slid both cams in and checked with both heads, the PTV, Radial clearance, and pushrod length was all checked and we are all set.
Radial clearances was checked with clay, Rod's pistons have a ton even with the 2.055 intakes on the ported set of heads, considering the rock of the piston as well.
Pushrods are all at 7.600 - they are all 7.595" long at the last point we checked them so I will be ordering them soon.
Just a quick update - Been working a ton, but have managed to get over to work on things a few times and have not updated.
Just about ready to balance after checking and re-checking everything - the shop was impressed with the BPE setup to say the least. They started recommending them to guys inquiring about SBM setups. The fit and finish was better then anything they have touched before in this price range.
Slid both cams in and checked with both heads, the PTV, Radial clearance, and pushrod length was all checked and we are all set.
Radial clearances was checked with clay, Rod's pistons have a ton even with the 2.055 intakes on the ported set of heads, considering the rock of the piston as well.
Pushrods are all at 7.600 - they are all 7.595" long at the last point we checked them so I will be ordering them soon.
