Help on 340 combo

If your not going to step up to ss spring or a cal trac set up, you need to atleast clamp the front segment of the leaf springs.

When i had my stock spring,i made front segment clamp out of some 1/8" inch steel plates. Don't remember the exact size now but they were like 1.5" wide by ......3" long.

Cut up two of these and then drill holes in the plate so there just out side of the width of the left spring. then us bolts and nylock nuts so you can just slightly snug then up and they won't fall off on you.(one plate on top fof leaf spring and the other on the bottom)

Add atleast one of these sets on each front segment of rear leaf spring.

Were on the front segment should you place these???

Up twowards the front spring loop, but not all the way. If you look real close at the front segment of the rear leaf spring, you will see were your bending the leaf spring......THATS THE EXACT SPOT YOU WANT TO PUT THE SPRING CLAMP.

You can take one of the spring clamps off of the rear segment of the spring and put it on the from segment, but, there ment more to keep the spring pack in line then any performace enhancement.