Harbor Freight Tool

Good (for mr so far):

The cheapest aluminum floor jack they sell is good just wish it would lift higher.

Impact sockets have been good. Haven't broken one yet.

56" tool box is good

Pry bar set hasn't broke yet

Jack stands are good

Foldable engine hoist is good but not very stable

Engine stand is good mounted a 5.2 magnum no problem but bent handle when turning engine.

Spot weld cutters work good just keep spraying WD40 and don't get them too hot

I was given the cheapest wire welder they make and it wasn't bad. Just had a horrible duty cycle.


Bad:

Body hammer and dolly set sucks broke heads off two hammers

trickle charger worked for first two months or so then quit.

Drill bits suck (this is one area where you get what you pay for)


Other:

I would recommend Kobalt air tools (Lowes) and compressor. I haven't had a problem out of any of the air tools I've got from them. 60 gal 3.5hp compressor, 1/2" impact, 3/8" ratchet, air nibbler, air hammer, right angle die grinder, cut off wheel.