Convertible interior's

Another little tip about restoring these panels just incase you decide to go that route...
The trim strip on it is vacuum metalised plastic just like the instrument bezel. To remove it and send it off for replating is one option but the chrome wont exactly match the stainless strip on the doors.
I started with an extra stainless strip from a door. Cut it in half ( 1 door piece covers both rear panels ) and trimmed these 2 pieces down until they were only a skin to slide over the plastic pieces. The plastic pieces had to be whittled down a little also so it fit inside the stainless.
How you finish the back end is up to you but what I did was cut a tiny opening through the panel and let the end of the stainless run right on through so that end of the stainless didn't need fit and finish.