I read this before too and I've heard that this specific issue is typical with the bars from PST, but not all torsion bar suppliers. When I was trying to decide, I narrowed it down to bars from Mancini (stock mopar, but they only go up to .096"), Hotchkis, or Firm Feel. Hotchkis only has large bars and I've heard from some that Firm Feel bars are good, but at least one person I know had an installation problem with those bars due to the hex head being longer than normal. Not sure if any of these 3 are offset. I bought mine from Mancini and the shop that installed had no problems.
Thanks for the reinforcement heads up! If I go up in size from my .092's I will need to check that out!
I asked the same question this summer.
Factory bars are made with about a 30 deg offset.
Aftermarket are most of the time are 0 deg.
I also ended up with almost no adjustement in my 1.030 bars.
