name of this part?
I thought they were gerfriblets... Ha, but seriously a picklefork and a BFH will get them off. If they dont unthread easily m (one is LHT) then chances are you'll struggle to get one out then the other will snap off. These are cast parts ( tie rod ends) so they will snap if too much force is applied.
Heat, then quenchy with blaster on the male ends of the threads usually works best IMO
does any one know the name of the part in the picture with a circle around it? is goes from the wheel to the pitman arm.
I thought they were gerfriblets... Ha, but seriously a picklefork and a BFH will get them off. If they dont unthread easily m (one is LHT) then chances are you'll struggle to get one out then the other will snap off. These are cast parts ( tie rod ends) so they will snap if too much force is applied.
Heat, then quenchy with blaster on the male ends of the threads usually works best IMO
