Upgrading 1965 Barracuda brake lights
There are a total of three gaskets. The round one you have shown. Then there is a foam one on the back. Finally a rubber bumper between the foam gasket and the body. I know Laysons has the foam between the bumper and tail light housing and I think they also have the bumper. If he doesn't you can get it from
http://shop.detroitmuscletechnologies.com/64-65-Barracuda_c36.htm
65Valiant:
I would be interested in the exact type of LED replacement you used. I have never found one even close to the output 1157 in the daytime - or I sure would not have put this much work in to it.
If you mean the gaskets for the lenses themselves, you can buy them from http://www.detroitmuscletechnologies.com/
I simply cut my own from EVA foam sheet:
If you are looking for the molded trim that goes around the outer edge of the housing between the housing & body - they are very hard to find. They were injection molded, and can't be cut from flat sheet.
B.
There are a total of three gaskets. The round one you have shown. Then there is a foam one on the back. Finally a rubber bumper between the foam gasket and the body. I know Laysons has the foam between the bumper and tail light housing and I think they also have the bumper. If he doesn't you can get it from
http://shop.detroitmuscletechnologies.com/64-65-Barracuda_c36.htm
