a sebring interior for my 66 dart

toplscuda said
98 still had the module under the console. I took a plazma to it and pulled absolutely everything out of the donor. Getting the cross brace out the bottom of the rear seats snap in to was fun because when I cut it out the car wanted to fold in to itself. Hopefully i can make some progress on getting the quarters on the car before spring so I can move to getting the interior situated. I originally got the idea to swap the interior when I was installing the new top on my 04 Sebring. I had pulled the rear seat out and had it sitting on to of the original seat from the 68. Thas when I noticed they were almost the same width.

ok I wasn't sure what year it changed over , I have to go a pickin to get my backseat brace. I'm measuring now and it looks like I'll have to remove 1 inch per side on the top of the seat back to give my top sidepanel covers room to move and 1 1/2 inch per side on the seat bottom so it doesn't look all scrunched up. that's ok since it's all foam and I'll have a professional upholsterer's help making sure I don't do a "stupid" hack job. I did test the power seat, I have a slow motor for the up/down. the rest of them work just fine. even the module when powered up unlocks the belts and locks up when I jerk the module forward or backwards by hand. so it all looks good.
front brackets are going to be a little more work than I wanted but I wanted the seats in 1 inch further toward the tunnel than the brackets allow. so a little finessing/adjusting/fiddling(maybe a big hammer) is called for.