Re-starting Dash making.....

Wasn't trying to mis-lead on the pricing. I had a few (3) faceplates of the short dash that I was going to complete and sell for $275. I then elected to re-start the complete manufacturing process, and held off listing prices because I didn't have current manufacturing costs. I chose to be accurate with current pricing, and the records I have indicate the last time RMD sold dashes, they cost, $512-799.

The majority of the cost in manufacturing the dash is in the gauge hole part of the dash, ie. in the holes and the tubes; there's also bezels for the radio and dash cover if that's what your interested in. To add a longer piece of aluminum to the right side is relatively inexpensive. I decided not to add a "proportional amount" to the price just because it was longer.

AS far as trimming the dash frame, the upper-most left corner needs to be clearanced about 1/4" for the standard tubes to fit, and the lowest small tube's position need about a 1/16" to fit. For the A-11, the brace behind the stock speedo needs to be moded because the original design had the speedo centered, and required a hole in that support.

My car is in process right now and I don't have the dash out to show ya'll specifics. I will have it out the last week of the month as I'm off work for the kid's Spring Break. I will post pics of installation and even a video then.

The older A-bodies' cluster's right side (pre-70) is straight up and down, not pointed, and I can do that too if those in that year group just want a cluster.

Sorry to stun ya'll. It wasn't my intent.