Doug Herbert solid cam?
Yes I am. It's noisy but the exhaust is way louder...:smile:
Do you think I could run it tighter?
ive run 3 of those .528 cams, they work better at the .028/
032 lash thats called for.
i like the 1st solid herbert cam u listed, it will make a lil more below and basically be more peakier in power. but really u should be flow testint the heads you just modified in order to now see what exh ratio and general flow curve u now have.
if going herbert....call them and tell them what u have combo wise,trans,gears,convertor ..to start...then tell them what cam ur running now and finally ..what you would like to see for power improvement & in what rpm u want it.
lunati also has some good solid grinds
really though.....if you just stab that .528 in about 6-10* advanced....
it will snap ur neck when stomp on it, and effectively lower the operating range/shift the power down lower in rpms...
advancing also makes up for a stingy int port...fwiw.