True enough, that is excatly what I did; however between the deck cut to 9.580 and the cut on my Eddies to get a 60cc chamber, my intake bottomed out on the end rails anyhow. RTV so thin it was transparent.
Wow you must have taken the Eddy's down quite a bit, maybe thin gaskets too. I have my 360 decked to 9.58 also but the heads are new EQ's with no milling. Had about 1/8" of space left. Yes it is good to keep it in mind and set the heads and intake on with the gaskets in place to check fitment before anything is installed in the lower end.
