Demon Clone Project

Here's the test fit with the frame secured with screws at the inner fenders. For unkown reason the rear frame had to be spaced up by 1/2 inch for all the other elevations to line up. This made me uncertain about the final fit but on the first try the fenders match up nicely.

I used measurements from the firewall just above the upper seam to each side of the front rad support in an x pattern and longitudinally to set the front to back position.

If I were doing it again I'd use points at the front and rear of the rockers rather than the closely spaced supports I have at the front of the rockers. I would not rely on the rear frame since what matters is alignment with the "cockpit". I would also cut wood angles to fit the rocker angles to make a level area for jack stand supports.