Intake Manifold Gasket ?

Pretty easy repair. take it slow and easy. Order cork valve cover gaskets as well, not the rubber ones. The important part is to make sure there is a nice bead of high quality silicone across the front and back and make sure there is a good bead at the short edges where the head, intake and block seal. Use a little 3M weather adhesive along the bottom edge in a couple 1" spots to keep the gasket from moving on you. Torque to 35 ft/lbs, Start in the middle and tighten one side then the other and work your way out. This is a very easy procedure. Outpatient and released the same day. Put rags across the open motor when cleaning off the old gaskets.