TTI Exhaust install 1964 v-8 Barracuda

When I got to the X-pipe I could tell where the interferance would be on the parking brake cable bracket, that was mentioned on the TTI website. Cut that bracket with Skil saw as close to the floorpan as possible. Removed the transmission crossmember and cleaned. Tried to free hand a line on both sides of the mount. Then made a templete to cut the crossmember following the instructions. Cut with a jigsaw as best possible, then did a trial fit with unwelded crossmember to see where I could do nothing more like where the frame could be in the way. Decided to only weld the flat part of the modified crossmember. Using the cut off part of the crossmember used most of that part that goes over the cross bolts and left the curved part unwelded. Glad that I did because I had to trim at the curved part some more.