TTI Exhaust install 1964 v-8 Barracuda

Now to start on the right front pipes, it will not fit without some work. Jack up the motor some and put a 3/4 inch thick board under the motor mount. That is all that is needed to put the pipe in to test fit, I removed the manifold thinking that was needed to get clearance till I tried a board under the motor mount. The front pipes will need to be massaged where it hits. It hit on the block, torsion bar and trans pan at the rear and the crossmember at a curve. Start marking and fix one at a time. Used a grinder on the bellhousing to get some clearance there. Cut off a ear at the back off the transmission. The pipe will fit, it just will take some work to make it happen. When the interferance is removed you can remove the board and get the pipe in and out without any extra work for test fitting.
edit: sorry about the double posting of the same pictures.