904 Governor Remove? can I do this?

Hello Folks,

I have a 904 with A transgo TF-3 Full Manual Valve Body in it.

I recently Snapped a Driveshaft and as a result, Cracked my Bellhousing.
Because of all this I had to get a new 904 case..

I am in the process of swapping in the Internals from the busted case to the New case, and While I had everything apart I am trying to do some refreshing & upgrades.

I am planning to Get rid of the stock Parking Gear in favor of an A&A trans Aluminum Parking gear to shed a few pounds.. With my TF-3 Valvebody Instructions it tells me to Block the Rear oil passage to the Governor - So my question is can I remove the Actual Governor from the Output shaft to lighten the Mass of the Rotating Assembly even more?


Thanks for your help!


Greg