HEI dist

This is what I bought. Must of had bad luck because it never worked right, right from the start. Called several times and don't feel that I got the help I needed. Just a lot of "hons" and what not. I was just outside in the garage and was looking it over again and noticed that the screws that hold the vacuum advance on had the heads mangled. It seems someone else tried to remove it or thats the way it came from the dealer. I will not speak for anyone else, but personally I will NOT buy anything else from that place again. I'm supposed to get another control module from them, was supposed to of been mailed on Wednesday the 4th of April, 2012. I'll give them until this coming Wednesday or maybe Friday before I put my feedback into Ebay. Look at the link here to see it.

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&vxp=mtr&item=350555151644

Ok, update. I received two new modules from them today. Seems that it was sent to the wrong address. I got home and put the whole thing back together and in the car. Started it up and same thing. Would run for about a minute then die. Well, I bypassed the ballast resistor and it works fine, no problem. Seems I needed a hot wire that don't go through the resistor. I had bought another resistor way back when I first got the car, and I tried that one with the same results. With the new distributor, it still goes through the resistor. When I get more time, I will find a way to get a keyed hot to go to the coil. So maybe the first module is ok then?