Brake drums rusted to spindle?

The factory original drums were drum and hub assemblies the studs and drum were swaged together to remove you must cut the studs off and grind them flush with the drum then drill a hole into the center of the stud from the wheel side about 1/4 deep (not all the way through) the drill bit size about 3/4 the diameter of the stud. This will allowed the swage to collapse as it is pushed through the hub. Then drive them out and press in new ones. Now the drum will slide on and off like the other side. Failure to follow these instructions will result in enlarging the holes in the hub and it being junk.

Brian