Intake Port Tumble

Well, this is about as good as it's going to get working with the meat that's available on the intakes. I cut into the VC bolt holes slightly removing the lumps, and the pushrod pinch is getting pretty thin as well. I made a template for width, then laid the angle of the pinch back as far as I could.
The cross section is still only .750", but I had to work off of the thinnest pushrod hole and make the rest of the ports' cross sections match. I put as gentle a radius as possible on the turn into the port behind the hump.

Opinions? Also, what should I do with the oddball guides? Anything other than maybe teardrop the bowl?

The center exhaust ports I just straightened at the exit, came out a pretty decent shape, about the same size as the 1-7 / 2-8 ports, which I just lightly cleaned up.

{I'm buying decent heads next time, the hell with all this grinding lol}