finished for the season

I took a dome light, an original Dart steering wheel center cap, a charger steeering wheel and a center cap I got at a swap meet....and began to hack!

I need some sort of spacer so the cap looked good on the wheel. I had a spare dome light and original dart plastic center cap.

I removed the metal mounting bracket insisde the original center cap and fastened it to the customized dome light housing. I think I used JB Weld or two part epoxy.

Once it set up, the center cap from the swap meet fastened perfectly to the mounting ring I took out of the original cap that was glued to the dome light housing. (I was looking all over the garage for something to make a spacer ring out of and the dome light just happened to fit)

Picture 1 is the dome light with center cap metal mounting bracket glued inplace.

Picture 2 is the same thing.

Picture 3 is the dome light housing attached to the spacer.

Picture 4 is a dome light.

Picture 5 is the back of the center cap as it came from the factory.

Picture 6 is an example of the 1968 Dart center cap I removed the mounting ring from.