Time For a rebuild

:sign3: Although he's not stupid ;)

To swap a Gen III hemi into an A-Body you generally need a mid-sump pan pan as explained by 5.7 Hemi above. However with an Alter-K-Tion you can use a truck rear sump pan as the alter-k-tion doesn't have a rear steering link to interfere with the pan. The only downside is that the stock truck pan would hang quite low. How low? Too low for my taste, it would probably be the lowest point on the car, certainly lower than the cross member on the alter-k-tion.

Final note, read through tincups 5.7 hemi build he spent a lot of time getting a decent oil pan for his hemi. Long Story short, I believe he ended up going with a Canton Oil pan. Not Cheap, but according to him very well made.

Best of Luck,

Regards,

Joe Dokes