Setting ride height/alignment with no motor

set the bars so that the LCA bumpers are 1" off the frame, bonuce the car a couple of times and reset

then go all the way in on the rear/ upper control arm adjuster, all the way out in the front...

then for toe go lock to lock, then center the wheel, tie or have some one hold the wheel... adjust till it starts getting close, then roll the car back and forth about 6 ft... re set toe and roll again and re inspect...

for toe measure the inner most tread groove on both fronts and both rears, the front should be about an 1/8" less than the rear... (toe in) / \