Upper control arm now won't fit

This is my first front end suspension project. I had all new bushings pressed in the LCAs and the UCAs. I installed the LCAs with no problem. Not so for the uppers. It seems that the bushings on the UCA (I only tried one side so far) are now spaced about 1/2" too wide for both to fit in the mounts. :wack: Did the guy who pressed in the bushings leave them a little short? Should I just use the home tool with the all-thread rod and press the bushings in further? Should I press both ends in equally? FYI - the car is a 1967 Barracuda vert.

Thanks for your advice! You guys rock!