Electronic Ignition Help
'Xacly EXCEPT the bottom diagram, showing "the yellow wire going to start relay" is WRONG
Should be from original brown bypass circuit coming out of bulkhead. If you originally had a 2 wire resistor for points, this will already be there.
In other words, "coming from points," you should have been able to hook the new resistor up in place of the old one, and LEAVE the wiring that was in place as is, then add the following:
1 two wires from the module to the dist. pickup
2 ground the module!!!
3 proper wire from the module to coil neg, hook the tack to coil neg if used
4 Now all you have left is module power. It goes to the KEY side of the ballast, not the coil side
In the top diagram, the ONLY thing was changed was the coil neg and to the left of that, and the blue from the module was ADDED
The coil + wiring, the resistor, and "to the right" of the diagram is "same as" original