tti header install

Just did mine with 4 sp., had to take torsion bar off pass. side and oil filter adaptor, had to make dent for tie rod end touching and also ding in for torsion bar barely touching. On driver side, easier fit as long as you raise the car ( 16 inches from under front tires) and the engine raise a couple of inches. Engine had to be raised on both side. Put z-bar upside down then bent lower arm to the engine about 1 1/8". EVERYTHING is close so make sure to have good engine mounts and torque limiter on driver side. Had to shim mounts with 3/16" steel plates for proper location ( 5 1/4" crank cl to top of crossmember) Offset at 2 1/2" was OK. Quite a bit more work than expected but Hotrodding is what it is...