20s for the Demon - how low can I go? (big wheel haters don't look)

I didnt think your question was "useless" it was just a waste since you are kinda in unchartered territory with that much wheel and tire on this forum so you are gonna have to basically figure it out and let everyone else know what works. My junk is on 18s....

Click to expand...

Just razzin you a bit. Your junk looks decent. Hope my junk turns out as well. I suspect your stance could work for me, maybe a little lower in the front. Mind giving out your tire sizes, and do you know your K member and rear frame clearances?

Edit: found it on your thread (275/35/18 front and 335/30/18 rear). Those are some beefy fronts - surprised they fit with stock front end. The 225/40 I was thinking of is 1/2" shorter at 25". I may need something taller unless I can go a bit lower.

excellant point from a "been there" member

big or small...I luv em all!...but that proportion thingy is kinda important when it comes to the overall look

Click to expand...

Point taken, will consider. I have not purchased anything yet. I plan to buy one front and one rear tire for mock up and return/change if necessary.

Still hoping for feedback on leaf spring travel - can't go forward with tubbing until I get that established. K-member height for header clearance also factors into my rear stance and tubbing plans.