turbo 6 bangers post here

srixon4406 said

Bill those line are little small if you have any problems when you start tuning you may have to upgrade your fuel system I'm using 1/2 inch on the feed and 3/4 on the return side
This is just my opinion but it's based off of hours of research I've done

As for the TOAD I'm going to put the drive shaft in in the morning and try and drive it up and down the driveway to make sure everything is good
The car is still in pieces but as long as all the mechanical side of the car is good putting back together shouldn't take me long but I still need to do the hotside piping and a front end alignment

Aaron

Click to expand...

Those lines we are using are the size (3/8") of the holes in the regulator.

A chain is only as strong as ts weakest link. If it still has to go through a 3/8" hole, how much good do you think it's going to do to have lines bigger than that?

I can't see it..

Tom Wolfe runs 3/8" lines and has no problem. He has the same pump and regulator that we do.

I think the secret is that, that Walbro pump puts out 60 psi... That will overcome a lot of distribution problems...

I think if it works for him, it will work for us, but I appreciate your interest!!!

Sounds like you may have your car operational in a matter of days!

Good for YOU!!!

We still have a ways to go...:-|