Attempt to Pay Back # 2

I was editing the post. No they will not clear as shown. I wll either cut the head off once I have it close. Or shorten the screws so when they are fully in the advance will set where I want it. There is .18 inch clearance between the plate and the inside wall of the distributor. Enouch room for head and nut but no lock washer. Tight no doubt. Now the other option is to use shorter screws and screw in from slot side. To get to around 8 degrees I have to screw the 2 56 in about 6 1/2 turns. That is a little over 1/10 of an inch, so the head is .845. So likely in that option I can get from 9 to 5 with no problem.