Wheel questions/68 Barracuda Coupe

You shouldn't need to remove a wheel to get the bolt pattern. Just use the pattern chart you have and measure as directed on the studs. The rear is easier to measure since tou don't have the long hub sticking out. As far as Wheel Vintiques I haven't had any issues personally. If you go with the chrome rally wheels all the trim rings would do is mess up the cgrome so I would say no on trim rings. I don't think they would look good on a chrome rally any way.

If you stick with the same sytle transmission and the factory rear end the dive shaft wouldn't need redone unless it was damaged. When you upgrade the rear end is where the drive shaft redo comes in to play.