Got new Champion aluminum radiator - starting install

The fans and shroud arrived today. I had some home landscaping and had to cut the grass as well, so I didn't get too much time put in to installing all the parts. Here is where I am at.
The fan shroud doesn't fit the radiator properly. The holes don't line up. I had to mark and drill new mounting holes in the shroud. Not a big deal. The fans don't come mounted to the shroud, and there aren't even any mounting holes. You have to drill your own. The fans come with a nice male wiring pigtail, but no female pigtail. How am I supposed to plug it in with only one end? Oh, and no instructions at all. I did use my power probe to verify the fans can spin either direction. I'll likely hard wire in one plug of my own instead of having two as they have it. I think I am going to wire in a relay as well.
The fan stuff is not as smooth as I had hoped but there is nothing insurmountable. I should have time tomorrow to finish it all up. I need to take the battery out to gain access so I can drill radiator mounting holes.

Out of the box. Pigtail and no corresponding plug. Nice.
View attachment Fans and shroud 2.jpg
View attachment Fan shroud 1.jpg
View attachment Fan wiring harness.jpg

Shroud drilled and ready to go.
View attachment Fan shroud.jpg

Fans mounted front and back view.
View attachment Fans and shroud.jpg
View attachment Fans and shroud 1.jpg

Set on the radiator. Looking at it makes me wonder how I am going to bolt the shroud to the radiator with the fans installed. And they have to be installed first. Gonna have to think on this one.
View attachment Fans and shroud ready to mount.jpg
View attachment Fans and shroud ready to mount 1.jpg