8.75 housing / axle help please

crackedback said
The tubes should be the same length. So one side is 1/4" short/long than the other

Greens and the spacer out should be good. I've had to trim the ends off an axle before to get them to fit.

thx rob i will go that route i know its minimal but wanted to make sure the one shorter tube by 1/4" wasn't gonna screw me.

Charrlie_S said
You only need to trim the axle, if you use green bearings, and leave the "block" in the rear. According to Randys, each axle needs to be trimmed 3/16 inch.
Just spoke to them about this last week. I'm using a borrowed Pig, with a SG and the block, but had axles with different bearings to choose from.

gonna trim axle if needed with green bearings. explain block? haven't heard the term. you mean the axle buttons?