Notched passenger side fenders?

Joe Dokes said

Are you using the TTI mounts?

Little surprised that it is that tight. The reality of these cars is that the tolerances of 60s and 70s manufacturing weren't very good. I've seen some of these swaps where the motor dropped in just fine while others had to shim, cut and scrape to get stuff to line up. :(

Regards,

Joe Dokes

Click to expand...

I am going to run TTI mounts and stock K for right now just so I can get all the parts in the car and tested. K-Frame design will begin once I hear it purr and the winter time is upon us.
For the time being I will just design enough adjustment in my trans Cross member so I dont end up building a new one when the new K-Frame goes in. So what does this haft to do with nothces?
Just hope I can devise a way to not notch and still make room and retain the stock look.