Show us your home made tools

jomoper said
Just had to add this tool I made today -a homemade control arm bushing puller .Total cost in materials $10.59 . I used a 2"W X 3"L threaded pipe with cap.Drilled hole off center ran allthread down the middle . Tighten the nuts and the bushing slides right out! Didn't take too much effort either. I did soak the a-arms in evaporust overnight.Should work just as well to install the new bushings .

I made one of these for the same reason (I think I might have copied yours). I found another purpose for it too! If you use a longer piece of all-thread you can use it as a slide hammer to remove the oil pump off a 904.