Hydroboost brackets

In terms of the making a Hydroboost kit fit a Gen III Hemi Car. I posted a question about this over at BigBlockDart.com and Bill Reilly responded with this nugget of information:

You have to take the mounting plate off and grind out the keyway, then rotate the unit until it clears the engine and retighten the plate. This requires a special tool with the mopar-specific one. Then you make an adapter for the mastercylinder so it mounts straight up, and add a spacer in the master the same thickness as the adapter you make, so the pushrod seats fully.

There is a shortcut now though. The universal-mount version can be easily rotated on it's steel mounting plate, so you only have to contend with the master cylinder rotation. However, the plate has to be drilled and trimmed for your firewall. It would save you from buying the GM Service tool to remove the plate at least.

So you can make the hydroboost work with the GenIII Hemi, but it will take some work, fabrication.

Regards,

Joe Dokes