400 low buck dont give a

well i put the short block back tog. to get some pics today.. and will try and load them tonight.. i put the 1/2 piston back in and tq everything back down to spec.. the piston are 3mm down in the hole.. dont know what that works out to be in th. as i loaned my calipers out about 4mths ago and dont have them back yet. i used a set of slide calipers not digital...the last 3 digits on the rods are 692 and the # on the pistons are 052 on the side and have a f on the other side...i used a washer to feel the gap from the top of the piston to the deck and the washer was just a bite to thick but you all can see the point.. i have no idea of whats been done to the block or what but hey i really dont care as long as it runs good..lol.. anyway i will keep you all posted on it.. i know it has a lot of look like 6 on the side of the block painted in white on both side about 3 per side...so now the build process will start.. do some oil mods ,pressure wash clean all the holes and run a tap down all of the bolt holes , forgot to look at the rod and main bearing # to see what they where..stay posted and we will see what she will do .....:D:D:D:D:D:D