replacing rockers

unfortionaly it will be hard to get any good pics,i have a pretty small garage and the jackstands are not very tall and i belive it will be lots of ours on my back on a cold floor no mather how i look at it:/

the more i look at the job the more i think that the worst part will be to find an angle to be able to reach the spotwelds holding the leafspringmounts to the rockers,i just cant figure out how to get a spotweld cutter in there without cutting the spotwelds from the outside,basicly having to cut out both layers forming the outer rocker just to get to the spotwelds that are under the car.

i have time,and patience simply because i have to,and a fairly good MIG welder only a 220volt,i would gues its similar to what is offered in the US as 110volt welders that i believe will do the job,im fairly confident in my welding skills since i weld quite alot where i work but thats a bigger 380 volt welder.

lol at the pic,i sort of wish it was "that" kind of rockers,much easier...

thanks for the help this far and feel free to ad more if you think of anything,will try to post some pics as i get further into this project.