Florida "Key Lime" 76 Duster Build

I start at the back of the car and work forward.....Big part of the stripe is easier to see and center to start with. I spray the area liberally with my solution so there are NO dry spots where the stripe is going..... Carefully peeling back a little of the backer (about 18" or so to start), I press the stripe onto it's starting point (determined by the rear and center body line)........I carefully place the rest of the stripe OVER the pinstripe guide to align it........When it's floated into place, I begin to "wipe" the stripe with my FELT squeegee.....(plastic will scratch the vinyl)......FIRST wiping lengthwise to "set" the stripe in place, THEN top to bottom to squeegee out the solution. After a short time of working the solution out, I CAREFULLY attempt to start peeling off the "mask" (wide tape that holds the vinyl stripe).......starting at the very end, I peel a tiny bit, holding the end of the black in place with my felt squeegee......then carefully and slowly proceeding, pressing the black vinyl down with the felt as I peel off the mask.........and the mask MUST be peeled at a VERY SHARP ANGLE as pictured....NEVER pull up.....pull sharply down and away.