Crane Fireball

Just getting ready to hook this system up, 72 440 duster with a ECU system.

#1- the thin red wire goes to the Ballast, I have the 4 pin set up. on one side there are two brown wires on the one spade and a blue on the other.

#2- on the other side of the Ballast there is a single brown on one spade then a jumper going to the other side, how do I hook it up here and what do I do with the remaining wires.

#3- the thin white wire goes to where the old UCU box pluged into before, does this wire get spliced into the black with yellow or white strip, eyes are bad not sure which colour the strip is.

#4- what do I do with the old ends that were hooked up to the old coil,

#5- I am also using there coil.

#6- I have wired it direct to the Battery, Red on Positive and Black on Negitive.

#7- I purchaced it used so no directions and the online ones do not tell which wires to use.

Thanks.