B&M shifter in stock console

Mad Dart said

Think you just changed my mind on how I am doing mine. Probably going to move the console back about 1-2" though and use the complete shifter set up.

Questions......

1) Did you cut the Selector Indicator off that points to PRND12 ??

2) Do you have any pictures of the Surgery under the console??

Click to expand...

1. i just bent it down. i still plan to cut it off and reposition it in the correct place.

2. all i did was cut off the factory shifter mt. put the shifter against the floor and laid the console over top then moved it where it needed to go and marked my holes. drilled the 4 holes and bolted it down. if i were to redo it i would have welded a flat steel plate to the tunnel for the shifter to sit on.