I wanted power windows for my 66 dart but I"m cheap!

I was having a problem getting the rear windows figured out since there's only about 3/4 inch clearance between the window mounting bracket and the regulator. that stopped me from doing it by mounting it oin the inside (back) like I wanted to and I couldn't find and motors that seemed to be small enough to not hit the brackets. So I did them this way. I cut a hole in the inner door panel and used the opposite side motor from a 99-2003 dakota and welded the mounting bracket on that way. So far so good I do have a lot of adjusting to do but I now have room to adjust the windows in or oout to fit the top.
here's the dakota motor and mounting bracket
View attachment DSCF3675.jpg
here's what it looks like after you get the pieces you need off of it
View attachment DSCF3677.jpg
here is all you have to remove from the old regulator(after you take spring OFF and crank section)
View attachment DSCF3678.jpg
then you cut a big gaping hole in your inner door panel
View attachment DSCF3674.jpg

and mount it

https://www.facebook.com/photo.php?v=386027634820193
here it is in action