Camshaft degree

Yes, that is true.......BUT........ that is .050" lift at the lifter, NOT THE VALVE and I only use that as sort of a double check. It is better to continue on until the lifter, in your case, is at .320" lift, note the degrees at that point, then continue on until the lifter has gone all the way over the nose of the cam and come back down to .320" lift, note the degrees, add the two degrees together and divide by two and that will give you the intake centerline. According to the cam ticket it should be 106 degrees, or 4 degrees advance, 110 lobe separation minus 106 centerline = 4 degrees advance.

The .320" is an arbitrary lift. You could use .280", .300", anything you chose as long as you use the same lift on each side of maximum lift.