steering coupler replacement (how to)

MERIDIAN said

The pin is inside the coupler, you need to disconnect the coupler from the steering box then slide off the coupler and inside with all the grease is the pin. knock the pin out, which isnt easy. use that hole for the bolt location on the new joint setup. Sorry if you did this but you will see it once taken apart, cant miss it.
Thanks

Click to expand...

I had to stick my finger inside the coupler to find the pin. On the outside it was hidden by all the dirt and grease. Ended up using a 3/32" pin punch and she came right out. Called Bryke racing and ordered that 3/4 - 36 spline U joint. Guy on the phone suggested I weld the non-spline side to the shaft because there was no hole. I'm guessing you drilled a hole? Thanks again!!