4 speed swap

Is the pad/mount for the z-bar to frame installed on the inner fenderwell?

Rear seal cant find it Brewers has them
Trans mount Cant find will the some mount from my auto work with this swap
The auto mount is the same for the 4 spd

Will I need this http://brewersperformance.com/proddetail.asp?prod=PB5300 There are different diameters so you need to measure the ID of the hole. Also, you need measure the depth of the crank hole so the shaft doesn't bottom out in the crank. Mount the bell to the trans, measure the length of the shaft, then measure from the rear of the block to the depth of the crank hole.

As I mentioned earlier, mount the bell to the block and measure the runout with a dial indicator. The bell must be centered w/the crank hole.