MSD E-curve Distributor Set Up???

BrianT said
Okay, I think I'm starting to get a grip on this now.

What about setting my initial timing at 10 degrees BTDC and then using the C advance curve? That would give me 35 degrees total advance by 2500 rpm. I have no problem in not using the vacuum advance setting. That would mean setting switch one to position 0 and switch two to position 3.

Am I looking at these charts right?!?

Stroker motors like a lot of initial timing or it will run like crap. Your going to want it in the 20* + Degree range on the initial. If not it will be very lazy and not have that crisp clean snap when you stab the throttle. Kinda like it is Loading up at idle.

Oh and YES you are reading the chart correct with your scenario above. You got it whipped now!!:D