68/9 cuda dash resto ???'s

While cleaning the circuit board and repainting the gauge needles(testors fluorescent orange...if I had some red I would have mixed it in to darken it a bit), I discovered that one of the copper pins for the big connector is loose...it hasnt fallen out/off but it aint far from it!! Seeing how its still attached, can it be soldered or something?? Is there a type of epoxy that will still allow electrical conduction??

Also these bulbs I believe are the same as the std 194 dash bulb, but it has a chromed/darkened lens on it...whats that for? I dont recall seeing these available anywhere?? Ideas where to get them...I can get std 194's but not the "mirrored" ones..

Thanks for the help/advice fabo!!
I