KH Brake Cleanup and Reassembly

You can use a multi purpose bearing grease or spend the extra $$ on synthetic. Just make sure it says for wheel bearings on the label.

Make sure the inside hole of the seal fits well on the spindle. I always tap them in lightly with a small hammer working in a circular motion. A better way would be to use a large socket that fits the seal to hammer it in so that it doesnt get crooked. They make bearing and race driver kits that have metal plates in all different sizes.

Honestly I dont recommend using the lug nut to pull the studs in. When you do it like that all the force is exerted on the threads and you can end up screwing them up. I have done it that way in the past with success but sometimes it pulls the threads right off. I used a shop press to install mine and it went much easier.