Roller Rocker geometry questions

Dude, the angle of the rocker stand vs valve stem, u lower the stem and the distance between the two increases and the the pattern moves toward the center/intake manifold side of head.

I Run into this all the time as with many valve jobs and half *** machinists forget to grind AND equalize the stem heights within factory spec.
Best thing you can do is ..with one valve just bolt up the rocker shaft with one arm and do a sweep/dye test and grind the stem a lil at a time till its right...then measure and grind the test to that height.

And quit with the "wrong again"****, you're not a game show host and this isn't a competition.