Take out the glove box and instrument cluster. You can reach above the heater box and reach the arm that goes to the passenger wiper. Take the arms out one at a time so you don't get confused which one goes where or how. I lubed up the snap in bushings with lithium grease and then set the arms on the ground and used a socket big enough to not hit the bushing and gave it a wack with a hammer to seat them. I first did the arm that attaches the wipers to each other. I set it back through the dash and used channel locks to attach the arm to the driver wiper pivot ball then moved over to the pass side and used a regular pair if pliers "cause there is no room" and attached that side to the pivot ball on the pass wiper. I used a good dab of lithium grease on each pivot ball before attaching them. I then took off the wiper motor and disconnected the Lil arm on the motor took it over to my vice using my aluminum shims so it wouldn't mark it up and pressed that end of the arm on that arms pivot ball. Then I installed that arm back in the dash and re attached the Lil arm back on the wiper motor and set the wiper motor back on the 3 studs and started the nuts a bit. I then went to the drivers side and attached the last end of the arm to the pivot ball with channel locks. I checked everything to make sure the bushings were seated all the way and then tightened up the 3 nuts on the wiper motor.............walah fixed wipers!!:D
