Hemi - 5speed - hydr clutch system

I am using the same dakota setup and bought my parts separately. I am going to use:
http://www.summitracing.com/parts/rus-641001/media/images and make my own hose to connect the two. I have heard without the bleeder you can bench bleed the system by pointing the master so the hose is in the air and pumping the crap out of it with the slave connected also with the hose facing up. This lets all the air make its way to the tank....I haven't tried it yet but I will be soon.

Its been a while since I've logged into the A-bodies site but my build thread is over on FBBO. I am putting a NV3500 Dakota trans behind my hemi in a Coronet.

I should also point out, to remove the hose to make it servicable you pull the roll pin out at the hose connection and it pops out.